Error Code: C-0103 Follow

Classification
PF: PF-602m paper feed motor abnormality
 

Cause
When the paper feed motor (M1) is active, an error detection signal of M1 is detected continuously for a specified period of time.
 

Measures to take when an alert occurs
The main body and the option stop immediately.
 

Estimated abnormal parts
• PF drive board (PFDB)
• Paper feed motor (M1)
• Front door open close switch (SW1)
• Front door open close sensor (PS23)
 

Correction
Press the help key to activate and deactivate the sub power switch (SW2) of the main body.
Note
▪ When you isolate the faulty part, the limited use is available.
▪ The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
▪ When you press the help key, the message "Please turn on power again" is displayed on the touch panel.
 

Solution
1. Check the connector connection and the wiring between PFDB and M1, and repair it when there is any abnormality.
2. Check IO Check (25-09) of SW1 and PS23, and repair or replace it when there is any abnormality (Wiring diagram: PF: 9-U, 10-U)
3. Check IO Check (28-02) of M1 and the coupling of the gear, and repair or replace it when there is any abnormality. (Wiring diagram: PF:19-U)
4. Replace M1.
5. Replace PFDB.
 

Faulty part isolation DIPSW
DIPSW35-0
DIPSW35-1
Control during the detachment
The PF paper feed is not available