Error Code: C-0202 Follow

Classification
Main body: Paper feed tray abnormality
 

Cause
Within a specified period of time after the paper lift motor/2 (M28) becomes active, the upper limit sensor/2 (PS43) does not become active.
 

Measures to take when an alert occurs
The main body and the option stop immediately.
 

Estimated abnormal parts
• Printer control board (PRCB)
• Paper lift motor/2 (M28)
• Upper limit sensor/2 (PS43)
 

Correction
Press the help key to activate and deactivate the sub power switch (SW2) of the main body.
Note
▪ When you isolate the faulty part, the limited use is available.
▪ The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
▪ When you press the help key, the message "Please turn on power again" is displayed on the touch panel.
 

Solution
1. Check the paper loaded condition and the rear end restriction plate condition of the tray 2, and repair it when there is any abnormality.
2. Check the connector connection between PRCB and M28, PS43, and the wiring. Then repair it when there is any abnormality.
3. Check the IO Check (23-01) of M28 and the coupling of the gear, and repair it when there is any abnormality. (Wiring diagram: Main body(1/5): 15-F)
4. Check the IO Check (16-01) of PS43 or the operation, and repair it when there is any abnormality. (Wiring diagram: Main body (2/5): 5-N)
5. Replace PS43.
6. Replace M28 and PRCB at a time.
 

Faulty part isolation DIPSW
DIPSW18-1
Control during the detachment
Paper feed in tray 2 is unavailable.