Error Code: C-0208 Follow

Classification
PF: PF-602m paper lift motor abnormality
 

Cause
The upper limit sensor/1 (PS1) does not become active within a specified period of time after the paper lift motor/1 (M2) becomes active.
 

Measures to take when an alert occurs
The main body and the option stop immediately.
 

Estimated abnormal parts
• PF drive board (PFDB)
• Paper lift motor/1 (M2)
• Upper limit sensor/1 (PS1)
 

Correction
Press the help key to activate and deactivate the sub power switch (SW2) of the main body.
Note
▪ When you isolate the faulty part, the limited use is available.
▪ The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
▪ When you press the help key, the message "Please turn on power again" is displayed on the touch panel.
 

Solution
1. Check the paper loaded condition and the rear end restriction plate condition of the PF tray, and repair it when there is any abnormality.
2. Check the connector connection and the wiring between PFDB, and M2 and PS1, and repair it when there is any abnormality.
3. Check the IO Check (23-07) of M2 and the coupling of the gear, and repair or replace it when there is any abnormality. (Wiring diagram: PF: 11-U)
4. Check the IO Check (23-07) and the operation of PS1, and repair or replace it when there is any abnormality. (Wiring diagram: PF: 6-K)
5. Replace PS1.
6. Replace M2.
7. Replace PFDB.
 

Faulty part isolation DIPSW
DIPSW35-0
Control during the detachment
Paper feed in the PF upper tray is unavailable