Menu

Error Code: C-1102 Follow

Avatar
Ohji Miranda

 

Classification

FS: FS-532 abnormality

Cause

The main tray up down motor (M301) does not become inactive even when a specified period of time elapses after it starts operations. Alternatively, it operates for more than the allowed time at a speed out of the specified one.

Measures to take when an alert occurs

The main body and the option stop immediately.

Estimated abnormal parts

  • FNS control board (FNSCB)
  • Main tray up down motor (M301)
  • Tray upper limit LED (LED1)
  • Main tray upper limit sensor (PS051)

Correction

Press the help key to activate and deactivate the sub power switch (SW2) of the main body.

Note

  • When you isolate the faulty part, the limited use is available.
  • The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
  • When you press the help key, the message "Please turn on power again" is displayed on the touch panel.

Solution

  1. Check the tray up and down section, and clean or repair it when there is any abnormality.
  2. Check the connector connection between FNSCB and M301, CN38 of FNSCB, CN111 of M301, and the wiring. Then repair it when there is any abnormality.
  3. Check the connector connection between FNSCB and LED1, CN46 of FNSCB, CN79 (Relay connector), CN140 of LED1, and the wiring. Then repair it when there is any abnormality.
  4. Check the connector connection between FNSCB and PS051, CN46 of FNSCB, CN154 of PS051, and the wiring. Then repair it when there is any abnormality.
  5. Check the IO Check (72-11), LED emission, and the light-receiving path of PS051, and repair it when there is any abnormality.
  6. Check the IO Check (72-15) of M301 and the coupling of the gear, and repair it when there is any abnormality.
  7. Replace LED1 and PS051.
  8. Replace M301.
  9. Replace FNSCB.

Faulty part isolation DIPSW

DIPSW6-4

Control during the detachment

FS main tray and stapling are not available

Articles in this section

See more