Error Code: C-1105 Follow

Classification

FS: FS-532 abnormality

Cause

The paper exit opening unit does not get to the specified opening position within a specified period of time after the paper exit opening motor (M111) starts operations.

Measures to take when an alert occurs

The main body and the option stop immediately.

Estimated abnormal parts

• FNS control board (FNSCB)
• Paper exit opening motor (M111)
• Paper exit opening sensor (PS111)

Correction

Press the help key to activate and deactivate the sub power switch (SW2) of the main body.

Note

• When you isolate the faulty part, the limited use is available.
• The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
• When you press the help key, the message "Please turn on power again" is displayed on the touch panel.

Solution

1. Check the paper exit opening section, and clean or repair it when there is any abnormality.
2. Check the connector connection between FNSCB and M111, CN27 of FNSCB, CN110 of M111, and the wiring. Then repair it when there is any abnormality.
3. Check the connector connection between FNSCB and PS111, CN48 of FNSCB, CN153 of M111, and the wiring. Then repair it when there is any abnormality.
4. Check the IO Check (72-13) and others of M111 and the coupling of the gear, and repair it when there is any abnormality.
5. Note
   • The output check on the IO check mode has restrictive conditions. Check the IO check mode list before the output check.
5. Check the IO Check (72-10) of PS111 or the operation, and repair it when there is any abnormality.
6. Replace PS111.
7. Replace M111.
8. Replace FNSCB.

Faulty part isolation DIPSW

DIPSW6-4

Control during the detachment

FS main tray and stapling are not available