Error Code: C-113A Follow
Code
C-113A
Classification
FS: SD-510 abnormality
Cause
The abnormality detection signal (ICP cut out) of the saddle stitching exit motor (M120) is detected.
Measures to take when an alert occurs
The main body and the option stop immediately.
Estimated abnormal parts
- FNS control board (FNSCB)
- Saddle stitching exit motor (M120)
Correction
Press the help key to activate and deactivate the sub power switch (SW2) of the main body.
Note
- When you isolate the faulty part, the limited use is available.
- The message "Please call service" and "Press [Help] to disengage" are displayed alternately on the touch panel.
- When you press the help key, the message "Please turn on power again" is displayed on the touch panel.
Solution
- Check the connector connection between FNSCB and M120, CN39 of FNSCB, CN45 (Relay connector), CN440 of M120, and the wiring. Then repair it when there is any abnormality.
- Rotate M120 by hand or the IO Check (72-49), and repair it when there is any abnormality.
- Replace M120.
- Replace FNSCB.
Faulty part isolation DIPSW
DIPSW17-1
Control while detached
The use of the half-fold, the fold&staple, and the tri-fold is unavailable.