Error Code: C-2432 Follow

Code

C-2432

Classification

Main body: TCR sensor/M initial adjustment abnormality (low density)

Cause

When the initial adjustment is performed with the TCR sensor/M (TCRS2), the output value of TCRS2 lowers the prescribed value.

Measures to take when an alert occurs

The main body and the option stop immediately.

Estimated abnormal parts

• Printer control board (PRCB)
• Developing motor/M (M6)
• TCR sensor/M (TCRS2)

Correction

Note

• The message "Please call service" is displayed on the panel.

Solution

1. Check that the process unit is correctly installed without looseness, and reinstall or repair it when there is any abnormality.
2. Check TCRS2, and clean or repair it when there is dirt or any abnormality. (Wiring diagram: Main body (2/5): 23-F)
3. Check the developing section, and clean or repair it if there is a sensor dirt or any abnormality.
4. Check the connector connection between PRCB and TCRS2, and the wiring. Then repair it when there is any abnormality.
5. Check the connector connection between PRCB and M6, and the wiring. Then repair it when there is any abnormality.
6. Rotate M6 with the IO Check (50-05) and other method. Then repair or replace it when there is any abnormality. (Wiring diagram: Main body (2/5): 19-E)
7. Replace TCRS2.
8. Replace M6.
9. Replace PRCB.

Faulty part isolation DIPSW

Control during the detachment