Error Code: C-2713 Follow

Code

C-2713

Classification

Main body: High voltage unit/2 abnormality

Cause

An error detection signal of the 1st transfer C is detected while the 1st transfer/C is active. The signal is detected even after you deactivate and activate the 1st transfer C for a prescribed time.

Measures to take when an alert occurs

The main body and the option stop immediately.

Estimated abnormal parts

• High voltage unit/2 (HV2)
• 1st transfer roller/C
• Printer control board (PRCB)

Correction

Note

• The message "Please call service" is displayed on the panel.

Solution

1. Check the connection of the high voltage contact of the process unit, and clean or repair it when there is any abnormality.
2. Check the connector connection between HV2 and the 1st transfer unit, and the wiring. Then repair it when there is any abnormality. (Wiring diagram: Main body (3/5): 7-M)
3. Check the connector connection between PRCB and HV2, and the wiring. Then repair it when there is any abnormality.
4. Replace HV2.
5. Replace PRCB.

Faulty part isolation DIPSW

Control during the detachment