Error Code: C-2832 Follow

Code

C-2832

Classification

Main body: Dot diameter correction abnormality

Cause

The proper value cannot be figured out within the specified time by the correction of the dot diameter correction/M.

Measures to take when an alert occurs

The main body and the option stop immediately.

Estimated abnormal parts

• Printer control board (PRCB)
• Developing unit/M
• IDC sensor/Fr (IDCS1)
• IDC sensor/Rr (IDCS2)
• IDC sensor shutter solenoid (SD4)
• Writing unit/M
• Image processing board (IPB)

Correction

Note

• The message "Please call service" is displayed on the panel.

Solution

1. Perform the IO Check (99-70) and check if there is a problem with IPB.
   • When the results are abnormal, perform solution 10 and solution 14.
   • When the results are normal, perform following solutions other than solution 14.
2. Check that the process unit is correctly installed without looseness, and reinstall or repair it when there is any abnormality.
3. Check that the writing unit is correctly installed without looseness, and reinstall or repair it when there is any abnormality.
4. Check the installation of the developing unit, and repair or replace it when there is an abnormality.
5. Check the IDC sensor and clean it if the sensor is dirty.
6. Check the IO Check (05-06) of IDCS1, and repair or replace it when there is any abnormality.
7. Note
   • The output check on the IO check mode has restrictive conditions. Check the IO check mode list before the output check.
7. Check the IO Check (05-12) of IDCS2, and repair or replace it when there is any abnormality.
8. Note
   • The output check on the IO check mode has restrictive conditions. Check the IO check mode list before the output check.
8. Check the connector connection between PRCB and IDCS1, and the wiring. Then repair it when there is any abnormality.
9. Check the connector connection between PRCB and IDCS2, and the wiring. Then repair it when there is any abnormality.
10. Check the connector connection between the writing unit and IPB, and the wiring. Then repair it when there is any abnormality.
11. Check the IO Check (55-00) of SD4 and repair or replace it when there is any abnormality.
12. Replace IDCS1 or IDCS2.
13. Replacing the developing unit.
14. Replace IPB.
15. Replace PRCB.

Faulty part isolation DIPSW

Control during the detachment